Toyota Celica 2005 Repair Manual page 1732

MX−14
2005 CELICA (RM1131U)
MANUAL TRANSAXLE (C56)
7.
(a)
D07395
(b)
NOTICE:
At the time of reassembly, please refer to the following
item.
When fixing the lever lock pin, properly position the shaft
groove.
(c)
NOTICE:
D07396
At the time of reassembly, please refer to the following
items.
S
S
8.
(a)
FIPG
(b)
HINT:
At the time of reassembly, please refer to the following item.
Apply FIPG to the transmission case cover, as shown in the il-
D07400
lustration.
− MANUAL TRANSAXLE ASSEMBLY
REMOVE CONTROL SHIFT LEVER AND DUST BOOT
Remove the nut and wave washer.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
Using a pin punch and hammer, drive out the lever lock
pin.
Remove the control shift lever and dust boot.
Install the dust boot into a groove in the control shift
lever.
Be sure to install the dust boot in the correct direc-
tion, as shown in the illustration.
REMOVE TRANSMISSION CASE COVER
Remove the 9 bolts.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
Using a brass bar and hammer, carefully tap the projec-
tion of the transmission case cover to remove the trans-
mission case cover from the transmission case.
FIPG:
Part No. 08826−00090, THREE BOND 1281 or equiva-
lent
1731