Toyota Celica 2005 Repair Manual page 2172

SUPPLEMENTAL RESTRAINT SYSTEM
LH
RH
2005 CELICA (RM1131U)
− DOOR SIDE AIRBAG SENSOR
INSTALLATION
HINT:
For step 2 to 5, refer to page BO−21.
1. INSTALL DOOR SIDE AIRBAG SENSOR
(a) Install the door side airbag sensor with the 2 bolts.
Torque: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
NOTICE:
Connection of the connector is done after the sensor
S
has been installed.
H11994
Make sure the sensor is installed with the specified
S
torque.
If the sensor has been dropped, or there are cracks,
S
dents or other defects in the case, brackets or con-
nector, replace the removed sensor with new one.
The door side airbag sensor is equipped with an elec-
S
trical connection check mechanism. Be sure to lock
this mechanism securely when connecting the con-
nector. If the connector is not securely locked, a mal-
function code will be detected by the diagnostic sys-
tem.
HINT:
Install the door side airbag sensor with the arrow on the sensor
facing toward the front of the vehicle.
(b) Connect the front airbag sensor connector.
2. INSTALL DOOR TRIM
3. INSTALL FRONT DOOR LOWER FRAME BRACKET
GARNISH
4. INSTALL OUTER MIRROR SWITCH ASSEMBLY
5. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL
H06709
2171
RS−71
RS0KR−02