Toyota Celica 2005 Repair Manual page 2373

Primer M
Primer M
Primer M
Adhesive
Primer G
c
c
Primer G
a − a
b − b
2005 CELICA (RM1131U)
BODY
5.
Using a brush, coat Primer M to the exposed part of body on the
vehicle side.
NOTICE:
S
S
S
H02865
6.
a
(a)
a
b
b
(b)
NOTICE:
S
c − c
S
7.
(a)
HINT:
After cutting off the tip, use all adhesive within the time de-
Primer G
scribed in the table below.
H12609
(b)
− BACK DOOR GLASS
COAT CONTACT SURFACE OF BODY WITH PRIMER
"M"
Allow 3 minutes or more to dry the primer coated sur-
face.
Do not coat Primer M to the adhesive.
Do not keep any of the opened Primer M for later use.
COAT CONTACT SURFACE OF GLASS WITH PRIMER
"G"
Using a brush or sponge, coat the edge of the glass and
the contact surface with Primer G as shown in the illustra-
tion.
When the primer is coated wrongly to the area other than
the specified, wipe it off with a clean shop rag before the
primer dries.
Allow 3 minutes or more to dry the primer coated sur-
face.
Do not keep any of the opened Primer G for later use.
APPLY ADHESIVE
Cut off the tip of the cartridge nozzle.
Part No. 08850−00801 or equivalent
Temperature
35°C (95°F)
20°C (68°F)
5°C (41°F)
Load the cartridge into the sealer gun.
2372
BO−67
Tackfree time
15 minutes
100 minutes
8 hours