Toyota Celica 2005 Repair Manual page 2121

RS−20
SUPPLEMENTAL RESTRAINT SYSTEM
2 Times or more
SST
2005 CELICA (RM1131U)
(2)
CAUTION:
Tightly wind the wire harness around the bolts so that
S
there is no slack.
If there is slackness in the wire harness, the steering
S
wheel pad may come loose due to the shock when the
airbag is deployed. This is highly dangerous.
H03202
(3)
CAUTION:
Make sure that the wire harness is tight. It is very dan-
S
gerous when looseness in the wire harness results in
H03203
the steering wheel pad coming free due to the shock
from the airbag deploying.
Always tie down the steering wheel pad with the pad
S
side facing upward. It is very dangerous if the steer-
ing wheel pad is tied down with the metal surface fac-
ing upward as the wire harness will be cut by the
shock from the airbag deploying and the steering
wheel pad will be thrown into the air.
NOTICE:
The disc wheel will be marked by airbag deployment, so
when disposing of the airbag use a redundant disc wheel.
(e) Check functioning of the SST (See step 1−(a)).
SST
Battery
AB0158
2120
− STEERING WHEEL PAD AND SPIRAL CABLE
Using 3 wire harnesses, wind the wire harness at
least 2 times each around the bolts installed on the
left and right sides of the steering wheel pad.
Face the upper surface of the steering wheel pad
upward. Separately tie the left and right sides of the
steering wheel pad to the disc wheel through the
hub nut holes. Position the steering wheel pad con-
nector so that it hangs downward through a hub
hole in the disc wheel.
09082−00700