Toyota Celica 2005 Repair Manual page 1934

Hide thumbs Also See for Celica 2005:

Table of Contents

2005 CELICA (RM1131U)

SUSPENSION AND AXLE

The clearance between the dust cover and bearing should be

kept in the ranges as shown in the illustration.

FRONT DRIVE SHAFT

REASSEMBLE INBOARD JOINT SHAFT

Install dust cover.

Using a press, install a new dust cover.

LH shaft of 1ZZ−FE engine (M/T) and 2ZZ−GE engine:

Using a snap ring expander, install a new outer snap ring.

Install center bearing.

Using a pin punch and hammer, install the straight

pin into the center bearing case.

Using SST and a press, install a new center bearing

into the bearing case.

09950−60010 (09951−00650),

09950−70010 (09951−07150)

Using a screwdriver, install a new outside snap ring.

Using SST and a press, install the center bearing

with the bearing case assembly to the inboard joint

09710−30021 (09710−03141)

Using a snap ring expander, install a new inside

Using SST, an extension bar and press, install a

new dust cover.

Show Quick Links

Table of Contents