BO−118
2005 CELICA (RM1131U)
BODY
−
SEAT BELT PRETENSIONER
INSTALLATION
NOTICE:
Never use seat belt pretensioner from another ve-
S
hicle. When replacing parts, replace them with new
parts.
Make sure that the front seat outer belt is installed
S
with the specified torque.
If the front seat outer belt has been dropped, or there
S
are cracks, dents or other defects in the case or con-
nector, replace the front seat outer belt with a new
one.
When installing the front seat outer belt, take care that
S
the wiring does not interfere with other parts and is
not pinched between other parts.
1.
INSTALL RETRACTOR OF FRONT SEAT OUTER BELT
(a)
Install the retractor of front seat outer belt with the 2 bolts.
Torque:
Upper bolt: 7.5 N·m (76 kgf·cm, 66 in.·lbf)
Lower bolt: 43 N·m (440 kgf·cm, 32 ft·lbf)
(b)
Connect the pretensioner connector as shown in the il-
lustration.
(c)
Connect the retractor switch connector.
2.
INSTALL FRONT SEAT OUTER BELT SHOULDER AN-
CHOR
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
3.
INSTALL FRONT SEAT OUTER BELT FLOOR AN-
CHOR
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
H12648
4.
INSTALL QUARTER TRIM PANEL
5.
INSTALL REAR SEAT OUTER BELT FLOOR ANCHOR
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
6.
INSTALL REAR SEATBACK LOCK STRIKER
7.
INSTALL REAR SEATBACK HINGE
8.
INSTALL DECK TRIM SIDE PANEL
9.
INSTALL REAR DECK TRIM COVER
10.
INSTALL LUGGAGE COMPARTMENT MAT
11.
INSTALL LUGGAGE COMPARTMENT TRAY
12.
INSTALL REAR SEAT (See page BO−105)
13.
INSTALL PACKAGE TRAY TRIM
14.
INSTALL DOOR SCUFF PLATE
2423
BO2OI−04