Toyota Celica 2005 Repair Manual page 1497

2
4
3
8
7
45°
45° Painted
Mark
Front
45°
45°
2005 CELICA (RM1131U)
ENGINE MECHANICAL
(a)
10
6
9
(b)
5
1
(c)
If any of the bearing cap sub−assembly bolts does not meet the
A01204
torque specification, replace the bearing cap sub−assembly
bolt.
(d)
(e)
(f)
9.
(a)
A01203
(b)
(c)
10.
− CYLINDER BLOCK
Apply a light coat of engine oil on the threads and under
the bearing cap sub−assembly bolts.
Install and uniformly tighten the 10 bearing cap sub−as-
sembly bolts, in several passes, in the sequence shown.
Torque: 22 N·m (225 kgf·cm, 16 ft·lbf)
Retighten the bearing cap sub−assembly bolts, in several
passes, in the sequence shown.
Torque: 44 N·m (449 kgf·cm, 32 ft·lbf)
Mark the front of the bearing cap sub−assembly bolts with
paint.
Retighten the bearing cap sub−assembly bolts by 45°
and 45° in the numerical order shown.
Check that the painted mark is now at a 90° angle to the
front.
INSTALL HEXAGON HEAD BEARING CAP SUB−AS-
SEMBLY BOLTS
Install and uniformly tighten the 10 bearing cap sub−as-
sembly bolts in several passes.
Torque:
1ZZ−FE: 18.5 N·m (189 kgf·cm, 14 ft·lbf)
2ZZ−GE: 18 N·m (185 kgf·cm, 13 ft·lbf)
Check that the crankshaft turns smoothly.
2ZZ−GE:
Apply adhesive to 2 or 3 threads, and install the 4 screw
plugs.
Adhesive:
Part No. 08833 − 00070, THREE BOND 1324, or equiv-
alent
Torque: 43 N·m (438 kgf·cm, 32 ft·lbf)
CHECK CRANKSHAFT THRUST CLEARANCE (See
page EM−100)
1496
EM−111