Samsung S3C2451X User Manual page 477

S3C2451X RISC MICROPROCESSOR
SD COMMAND ISSUE SEQUENCE
(1) Check Command Inhibit (CMD) in the Present State register. Repeat this step until Command Inhibit (CMD) is
0. That is, when Command Inhibit (CMD) is 1, the Host Driver shall not issue a SD Command.
(2) If the Host Driver issues a SD Command with busy signal, go to step (3). If without busy signal, go to step (5).
(3) If the Host Driver issues an abort command, go to step (5). In the case of no abort command, go to step (4).
Figure 21-9 Timeout Setting Sequence
Preliminary product information describe products that are in development,
for which full characterization data and associated errata are not yet available.
Specifications and information herein are subject to change without notice.
HSMMC CONTROLLER
21-9