Show Hardware Layer2 - Dell Z9500 Command Reference Manual

L3Routable
OutPort
param2=0(0), param3=0(0)}
EID 0x0000130d: gid=0xd,
flags=0x10202, Installed, Enabled
StageEgress
flags=0x10204, Installed, Enabled
IpType
L3Routable
OutPort
param2=0(0), param3=0(0)}
{Packets}
Usage The port-set values are internal port numbers. For a cross reference of the internal
Information and port numbers, refer to the Debugging and Diagnostics chapter in the Dell
Networking OS Configuration Guide for the Z9500 System.

show hardware layer2

Display information about the Layer 2 ACLs used on a Z9500 line card and port pipe.
Z9500
Syntax
show hardware layer2 {eg-acl | in-acl} linecard slot-id port-
set number
Parameters
eg-acl | in-acl
690
DATA=0x00000004
MASK=0x0000000c
Offset: 166 Width: 1
DATA=0x00000001
MASK=0x00000001
Offset: 195 Width: 7
DATA=0x00000001
MASK=0x0000007f
action={act=Drop, param0=0(0), param1=0(0),
policer=
statistics=NULL
slice=0, slice_idx=0x1, part =0 prio=0x130d,
tcam: color_indep=0,
slice=1, slice_idx=0x1, part =1 prio=0x130d,
tcam: color_indep=0,
Offset: 208 Width: 5
DATA=0x00000004
MASK=0x0000000c
Offset: 166 Width: 1
DATA=0x00000001
MASK=0x00000001
Offset: 195 Width: 7
DATA=0x00000001
MASK=0x0000007f
action={act=Drop, param0=0(0), param1=0(0),
policer=
statistics={stat id 110
Enter either the keyword eg-acl or the keyword in-acl to
display ingress or egress ACL data.
slice = 0 idx=4 entries=1}
Debugging and Diagnostics