Dell Z9500 Command Reference Manual page 691

linecardslot-id
port-set
number
Defaults none
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
Usage The port-set values are internal port numbers. For a cross reference of the internal
Information and port numbers, refer to the Debugging and Diagnostics chapter in the Dell
Networking OS Configuration Guide for the Z9500 System.
Example
Dell#show hardware layer2 acl eg-acl linecard 2 port-set 0
EID 0x000010ce: gid=0x10,
flags=0x10202, Installed, Enabled
StageEgress
Color
param2=0(0), param3=0(0)}
{Packets}
EID 0x000010cd: gid=0x10,
flags=0x10202, Installed, Enabled
StageEgress
OutPort
param2=0(0), param3=0(0)}
Debugging and Diagnostics
Enter the linecard slot-id parameters to specify a
Z9500 line card. The range of slot IDs is from 0 to 2.
Enter the keywords port-set number parameters to
specify a port pipe (set of ports) on a line card. The range of
port-set numbers is from 0 to 3.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
slice=3, slice_idx=0, part =0 prio=0x10ce,
tcam: color_indep=0,
Offset: 22 Width: 2
DATA=0x00000001
MASK=0x00000003
action={act=RpDrop, param0=0(0), param1=0(0),
policer=
statistics={stat id 62
slice=3, slice_idx=0x1, part =0 prio=0x10cd,
tcam: color_indep=0,
Offset: 193 Width: 7
DATA=0x00000000
MASK=0x0000007f
action={act=RpDrop, param0=0(0), param1=0(0),
slice = 3 idx=0 entries=1}
691