Common Output Fields - Avaya S8700 Maintenance Manual

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Common Output Fields

Common output can be any of the following information:

An indication that the command successfully completed or a

self-explanatory message giving a reason for a failure or abort.

An input form for entering additional information required to complete the

command. These are described under each command that presents an

A form listing one or more lines of results with error codes that indicate the

reason for a FAIL or ABORT result.

Many commands that use the last form display the fields listed in the table below.

Some return one line of output. Other commands that run either one test on

several objects or several different tests on one or more objects return several

lines of output. In this case, each line represents one test result.

The length of this variable differs for the various types of commands. A port circuit

requires a full-length address such as 11C1502, indicating circuit number 2 on the

circuit pack in cabinet 11, carrier C, slot 15. A control carrier component, such as

an IPSI, is designated simply as 01B , indicating the component in carrier B of

Some MOs such as TDM-BUS are addressed by PN number. In this case, the

number is usually preceded by PN. For example, TDM bus A in port network 5 is

designated as PN 05A .

In critical-reliability systems, port network connectivity is duplicated as two

independent sets of PNC components. These are designated as A-PNC and

1- or 2-digit cabinet number

Letter designation of a circuit pack carrier

1- or 2-digit number identifying a circuit pack slot on a carrier

1- or 2-digit number identifying an individual port circuit on circuit

The address or physical location of the MO. Usually this is

Issue 1 May 2002