Table of Contents
Advertisement
Connect PC and Printer
To be able to configure the COMmander Basic, it must be connected to
a PC with the configuration software installed. There are three options
for the connection of the PC:
Your PC is directly connected via serial port with the PBX
If the PC is not next to the PBX, it is recommended to connect via
fixed wiring. The cable (9-pole) and case adapter are enclosed (see
also
page
34). (recommended for creating a basic configura-
tion)
Connection between PC and USB port of a system telephone COM-
fort 1200 or 2000 on the internal S
requires a USB interface on the PC (see also
Your PC is connected with the COMmander Basic via an ISDN PC-
controller with CAPI 2.0 driver software installed in your PC
(Pic.
47). This ISDN PC-controller is connected on the internal
ISDN bus. Therefore you need a CAPI 2.0 compatible ISDN PC-
controller (see also
page
34).
Pic. 45: COMfort 2000 on
internal S
Minimum Requirements for the PC
PC with Intel Pentium 266 or compatible processor
Windows 95, 98, Windows Me, Windows 2000, Windows XP or
Windows NT 4.0 with service pack 3 or later
but: Windows 98 SE, Windows Me, Windows 2000, Windows XP if
you use USB interface of the system telephone
RAM memory
for Windows 95/98/Me: 32 MB, 64 MB recommended
for Windows 2000/NT/XP: 64 MB, 128 MB recommended
USB interface (if used for the system telephone) according to USB
specification 1.1
CD-ROM drive
Mouse or compatible pointer device.
SVGA graphics board with a recommended resolution of at least
800 x 600 and 256 colors (8 bit), 32768 colors (15 bit) recom-
mended
25 MB hard disk space needed for the installation of COMset:
(Pic.
-Port of the PBX
(Pic.
45). This
0
page
34).
port
0
Connect PC and Printer
46).
Pic. 46: Connection:
serial interface
Pic. 47: ISDN PC-control-
ler on internal S
port
0
33
Advertisement
Table of Contents
