SSANGYONG Rexton Y200 Manual page 29

M162 Engine
M161 Engine
SSANGYONG Y200
ENGINE GENERAL INFORMATION 1A-15
Leakage Test
1. Warm the engine up to normal operating
temperature.
2. Disconnect the negative battery cable.
3. Remove the spark plugs.
4. Check the coolant level by opening the coolant
reservoir cap and replenish if insufficient.
5. Open the engine oil filler cap.
6. Connect the tester to air pressure line and adjust
the scale of tester.
7. Install the connecting hose to spark plug hole.
8. Position the piston of No.1 cylinder at TDC by
rotating the crankshaft.
YAD1A120
9. Connect the connecting hose to tester and
measure the leakage volume after blowing up
5 bar of compressed air.
Notice: Measure the leakage volume in the
completely opening condition of throttle valve by
pulling the acceleration cable.
10. Perform the pressure test according to the firing
order.
Notice:
Firing Order
•
M162 Engine: 1 - 5 - 3 - 6 - 2 - 4
•
M161 Engine: 1 - 3 - 4 - 2
11. Compare the leakage pressure with the
specifications.
YAD1A130