SSANGYONG Rexton Y200 Manual page 27

SSANGYONG Y200
ENGINE GENERAL INFORMATION 1A-13
Tools Required
001 589 76 21 00 Compression Pressure Tester
001 589 73 21 00 Hand Vacuum Pump
601 589 65 09 00 Socket
Measuring Procedure
Notice: Ensure that no gear is engaged and that
the vehicle is protected from rolling.
1. Run the engine to be the coolant temperature
80 °C (176 °F).
2. Remove the fuel injection nozzle.
YAD1A090
3. Install the test adapter (1) and connect the flexible
connector (2) to the compression pressure tester
001 589 76 21 00.
4. Disconnect the vacuum line from the stop unit and
connect the hand vacuum pump 001 589 73 21 00
to the stop unit.
5. Pump the hand vacuum pump 001 589 73 21 00
and make the fuel injection pump in stop position.
Operating Pressure
6. Using a starter motor, crank the engine 8
revolutions.
7. Measure the remaining cylinder compression
pressure in the same manner and compare it with
service data.
YAD1A100
Notice: If out of standard, do cylinder pressure
leakage test.
8. Remove the compression pressure tester 001 589
76 21 00.
9. Install the fuel injection nozzle.
Approx. 500bar