Toyota Celica 2005 Repair Manual page 1398

EM−12
Point Marks
2ZZ−GE:
1ZZ−FE:
SST
SST
2005 CELICA (RM1131U)
ENGINE MECHANICAL −
6. 1ZZ−FE:
REINSTALL CAMSHAFT
(a) Reinstall the valve lifters (See page EM−63).
(b) Align the crankshaft pulley groove with the timing mark "0"
of the timing chain cover.
(c) Hold the timing chain, and place the intake camshaft and
timing sprocket assembly.
(d) Align the matchmarks on the timing chain and camshaft
timing sprocket.
(e) Reinstall the camshaft and timing sprocket assemblies
(See page EM−67).
(f) Check that the point marks of the camshaft timing sprock-
ets are in straight line on the timing chain cover surface
as shown in the illustration.
(g) Check that the matchmarks are on the timing chain and
camshaft timing sprockets.
(h) Install the chain tensioner (See page EM−26).
(i) Recheck the valve clearance (See procedure in step 3).
(j) Check the valve timing (See page EM−26).
A10387
7. 2ZZ−GE:
REINSTALL ADJUSTING SHIM
(a) Lift the rocker arm to make a room and use SST, install the
adjusting shim.
HINT:
Setting SST from the right above makes the removal
S
easy.
To remove SST from the adjusting shim, it is advisable to
S
push down the rocker arm.
A13540
(b) Turn the crankshaft so that the related rocker arm, where
the valve clearance is adjusted, is fully pushed down.
NOTICE:
Pay attention to the direction of the rotation to prevent
S
the nose of the camshaft from interfering with the
SST's shaft.
Do not rotate the crankshaft excessively.
S
(c) After loosening the 2 set screws of SST, remove SST it-
self.
A13541
SST
1397
VALVE CLEARANCE
09248−77010 (09248−07010)