Toyota Celica 2005 Repair Manual page 1406

EM−20
2ZZ−GE
1ZZ−FE
2005 CELICA (RM1131U)
ENGINE MECHANICAL −
10. 2ZZ−GE:
REMOVE CYLINDER HEAD COVER
(a) Remove the 4 bolts and No. 2 cylinder head cover.
(b) Remove the ignition coils (See page IG−6).
(c) Disconnect the 2 PCV hoses from the cylinder head cov-
er.
(d) Remove the 2 nuts, bolt and disconnect the No. 3 ventila-
tion hose from the No. 1 ventilation pipe.
(e) Remove the No. 1 ventilation pipe and gasket.
A10385
(f) Remove the 9 bolts, wire harness protector, cylinder head
cover and gasket.
(g) Remove the O−ring from the cylinder head cover.
A10386
11. SET NO.1 CYLINDER TO TDC/COMPRESSION
(a) Turn the crankshaft pulley, and align its groove with timing
mark "0" of the timing chain cover.
B00273
(b) Check that the point marks of the camshaft timing sprock-
ets are in straight line on the timing chain cover surface
as shown in the illustration.
If not, turn the crankshaft 1 revolution (360°) and align the
marks as above.
A10387
1405
TIMING CHAIN