Toyota Celica 2005 Repair Manual page 1417

Gasket
Seal Width 4 − 5 mm
2005 CELICA (RM1131U)
ENGINE MECHANICAL
8. 2ZZ−GE:
FIPG
INSTALL TIMING CHAIN COVER AND WATER PUMP
Seal Width
(a) Remove any old packing (FIPG) material and be careful
1.5 mm
not to drop any oil on the contact surfaces of the timing
chain cover, cylinder head and cylinder block.
S
S
A10376
S
(b) Apply seal packing to the timing chain cover as shown in
the illustration.
Seal packing:
Part No. 08826−00100 or equivalent
S
HINT:
Avoid applying an excessive amount to the surface.
S
S
(c) Install the 2 gasket to the timing chain cover as shown in
the illustration.
(d) Apply seal packing to 4 locations as shown in the illustra-
tion.
Seal packing:
Part No. 08826−00080 or equivalent
S
HINT:
Avoid applying an excessive amount to the surface.
S
Seal
Packing
S
A10396
1416
− TIMING CHAIN
Using a razor blade and a gasket scraper, remove
all the old packing (FIPG) material from the gasket
surfaces and sealing grooves.
Thoroughly clean all components to remove all the
loose material.
Using a non−residue solvent, clean both sealing
surfaces.
Install a nozzle that has been cut to a 1.5 mm open-
ing.
Parts must be assembled within 3 minutes of ap-
plication. Otherwise the material must be removed
and reapplied.
Immediately remove nozzle from the tube and rein-
stall cap.
Install a nozzle that has been cut to a 4 − 5 mm (0.16
− 0.20 in.) opening.
Parts must be assembled within 3 minutes of ap-
plication. Otherwise the material must be removed
and reapplied.
Immediately remove nozzle from the tube and rein-
stall cap.
EM−31