Toyota Celica 2005 Repair Manual page 1412

EM−26
2ZZ−GE:
1ZZ−FE:
Upward
2005 CELICA (RM1131U)
ENGINE MECHANICAL
INSTALLATION
1.
(a)
(b)
NOTICE:
A10438
Do not push valve timing controller assembly to the cam-
shaft forcibly when installing it.
(c)
(d)
(e)
A10371
2.
(a)
A10393
(b)
Set Key
B00280
− TIMING CHAIN
INSTALL VALVE TIMING CONTROLLER ASSEMBLY
AND CAMSHAFT TIMING SPROCKET
Apply engine oil in the range from the tip of the intake
camshaft to 16 mm from that tip.
Align the timing mark on the value timing controller as-
sembly with the knock pin, and install the value timing
controller assembly to the camshaft.
Align the knock pin hole in the camshaft timing sprocket
with the knock pin of the camshaft, and exhaust the
sprocket to the camshaft.
Temporarily install the timing sprocket bolt.
Hold the hexagon wrench head portion of the camshaft
with a wrench, and tighten the timing sprocket bolt.
Torque: 54 N·m (551 kgf·cm, 40 ft·lbf)
SET NO. 1 CYLINDER TO TDC/COMPRESSION
Turn the hexagonal wrench head portion of the cam-
shafts, and align the point marks of the camshaft timing
sprockets.
Using a crankshaft pulley bolt, turn the crankshaft and set
the set key on the crankshaft upward.
1411
EM15S−08