Seal Width
1.5 mm
A
B
B
A
7 mm
12 mm
6 mm
4.5
mm
Seal Packing
2005 CELICA (RM1131U)
ENGINE MECHANICAL
Chain
Cover
Groove
Cylinder
Head
Groove
C
C
3 mm
A07223
Seal Width
4 − 5 mm
A10403
−
TIMING CHAIN
7.
1ZZ−FE:
INSTALL TIMING CHAIN COVER AND WATER PUMP
(a)
Remove any old packing (FIPG) material and be careful
not to drop any oil on the contact surfaces of the timing
chain cover, cylinder head and cylinder block.
Using a razor blade and a gasket scraper, remove
S
all the old packing (FIPG) material from the gasket
surfaces and sealing grooves.
Thoroughly clean all components to remove all the
S
loose material.
Using a non−residue solvent, clean both sealing
S
surfaces.
(b)
Apply seal packing to the timing chain cover as shown in
the illustration.
Seal packing:
Part No. 08826 − 00100 or equivalent
Install a nozzle that has been cut to a 1.5 mm (0.16
S
− 0.20 in.) opening.
HINT:
Avoid applying an excessive amount to the surface.
Parts must be assembled within 3 minutes of ap-
S
plication. Otherwise the material must be removed
and reapplied.
Immediately remove nozzle from the tube and rein-
S
stall cap.
(c)
Apply seal packing to 2 locations as shown in the illustra-
tion.
Seal packing:
Part No. 08826 − 00080 or equivalent
Install a nozzle that has been cut to a 1.5 mm (0.16
S
− 0.20 in.) opening.
HINT:
Avoid applying an excessive amount to the surface.
Parts must be assembled within 3 minutes of ap-
S
plication. Otherwise the material must be removed
and reapplied.
Immediately remove nozzle from the tube and rein-
S
stall cap.
1414
EM−29