Toyota Celica 2005 Repair Manual page 1419

SST
Raise
Push
Hook
Pin
Push
2005 CELICA (RM1131U)
ENGINE MECHANICAL −
(b) Install the drive belt tensioner.
Torque:
Bolt
1ZZ−FE 69 N·m (704 kgf·cm, 51 ft·lbf)
2ZZ−GE 100 N·m (1,020 kgf·cm, 74 ft·lbf)
Nut 29 N·m (296 kgf·cm, 21 ft·lbf)
(c) Hook the tool on the hexagonal portion of the drive belt
tensioner bracket and operate drive belt tensioner 3 times
with full stroke.
HINT:
Take 3 seconds or more for 1 full stroke.
15. INSTALL CRANKSHAFT POSITION SENSOR
Torque: 9.0 N·m (92 kgf·cm, 80 in.·lbf)
16. INSTALL CRANKSHAFT PULLEY
(a) Clean the crankshaft pulley inside.
(b) Align the pulley set key with the key groove of the pulley,
and slide on the pulley.
(c) Using SST, install the pulley bolt.
SST
Torque:
1ZZ−FE 138 N·m (1,409 kgf·cm, 102 ft·lbf)
2ZZ−GE 120 N·m (1,224 kgf·cm, 89 ft·lbf)
A21007
17. INSTALL CHAIN TENSIONER
(a) Check the chain tensioner.
(See page EM−16)
(b) Release the ratchet pawl, fully push in the plunger and ap-
ply the hook to the pin so that the plunger cannot spring
out.
A07224
(c) Insert the O−ring with your hand until it reaches to the
chamfering position and install nut temporally. Then, by
tightening the nut, insert the chain tensioner to the instal-
lation position.
HINT:
In the case that the hook is released while pushing in, ap-
S
ply the hook again and push the tensioner in.
Pay attention not to catch the O−ring as it is built in the
S
chain tensioner previously.
A07317
1418
TIMING CHAIN
09960−10010 (09962−01000, 09963−01000)
EM−33