Toyota Celica 2005 Repair Manual page 1418

EM−32
B
B
B
A
A
A
2ZZ−GE:
2005 CELICA (RM1131U)
ENGINE MECHANICAL
B
B
B
C
C
D
C
D
B
C
B
B
B
A10397
A10388
− TIMING CHAIN
(e) Install the timing chain cover, O−ring and water pump with
the 19 bolts. Uniformly tighten the bolts in several passes.
Torque:
A: 21 N·m (214 kgf·cm, 15 ft·lbf)
B: 11 N·m (113 kgf·cm, 8 ft·lbf)
C: 9.0 N·m (92 kgf·cm, 80 in.·lbf)
D: 9.0 N·m (92 kgf·cm, 80 in.·lbf)
NOTICE:
Pay attention not to wrap the chain and slipper over
S
the chain cover seal line.
After install the chain cover, must install the mount-
S
ing bracket and water pump within 15 minutes.
(f) Using a torx® wrench socket (E8), install the stud bolt.
Torque: 9.3 N·m (95 kgf·cm, 82 in.·lbf)
9. 2ZZ−GE:
INSTALL EXHAUST MANIFOLD (See page EM−67)
10. 2ZZ−GE:
INSTALL EXHAUST MANIFOLD STAY
(See page EM−67)
11. 2ZZ−GE:
INSTALL FRONT EXHAUST PIPE (See page EM−67)
12. 1ZZ−FE:
INSTALL RH ENGINE MOUNTING BRACKET
(a) Apply seal packing to threads of the mounting bolt.
Seal packing:
Part No. 08826 − 00080 or equivalent
HINT:
Do not apply seal packing to 2 or 3 threads of the bolt end.
(b) Install the mounting bracket with the 3 bolts.
Torque: 47 N·m (479 kgf·cm, 35 ft·lbf)
13. 2ZZ−GE:
INSTALL RH ENGINE MOUNTING BRACKET
Install the mounting bracket with the 4 bolts.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
14. INSTALL DRIVE BELT TENSIONER
(a) Check the appearance before installing the drive belt ten-
sioner.
If in case of having the oil leakage, crack, and etc., replace the
drive belt tensioner.
1417