Toyota Celica 2005 Repair Manual page 1420

EM−34
Disconnect
Hook
Pin
Plunger
Push
2ZZ−GE:
1ZZ−FE:
2005 CELICA (RM1131U)
ENGINE MECHANICAL
(d)
18.
(a)
Turn
A10405
(b)
Turn
A10406
HINT:
If the plunger does not spring out, press the slipper into the
chain tensioner with a screwdriver or your finger so that the
hook is released from the knock pin and the plunger springs out.
19.
(a)
NOTICE:
Always turn the crankshaft clockwise.
A10407
(b)
If not, turn the crankshaft 1 revolution (360°) and align the
marks as above.
A10387
− TIMING CHAIN
Tighten the 2 nuts.
Torque: 9.0 N·m (92 kgf·cm, 80 in.·lbf)
SET CHAIN TENSION
Turn the crankshaft counterclockwise, and disconnect
the plunger knock pin from the hook.
Turn the crankshaft clockwise, and check that the slipper
is pushed by the plunger.
CHECK VALVE TIMING
Turn the crankshaft pulley, and align its groove with timing
mark "0" of the timing chain cover.
Check that the point marks of the camshaft timing sprock-
ets are in straight line on the timing chain cover surface
as shown in the illustration.
1419