Changing Configuration Inside Of Hdd Case Unit - Canon imageRUNNER ADVANCE 6075 Series Service Manual

7) Affix the HDD No.1 of the R-HDD Label to the handle of the Removable HDD.
8) Write down the serial number of the host machine to the label for recording the number,
and affix it to the area indicated in the figure.

■ Changing Configuration inside of HDD Case Unit

1) Remove the E-ring from the removed HDD Case Unit, remove the shaft of the HDD Cap,
and then remove the HDD Fixed Plate. (The removed HDD Fixed Plate will not be used.)
HDD Fixed Plate
2) Put the HDD Cap and the shaft back to the HDD Case Unit, and secure the HDD Case Unit
with the E-ring.
9
Installation > [TYPE-10] Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Changing Configuration inside of H
HDD No.
Serial No.
XXXXXXXX
F-9-594
F-9-595
9 Installation > [TYPE-10] Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Changing Configuration inside of H
3) Remove the Upper Rail from the HDD Case Unit.
• 2 Screws (The removed screws will be used in step 6).)
x2
4) Remove the Leaf Spring from the removed rail in the order of the arrows in the figure
below. (The removed Leaf Spring will not be used.)
• 2 Bosses
• 2 Arms
Boss
Boss
Turn over
9-298
F-9-596
Arm
F-9-597
9-298