Canon imageRUNNER ADVANCE 6075 Series Service Manual page 1241

4) Fit the 2 bosses of the Connector Fixation Screw into the holes of the Conversion
Connector to install, and tighten the screws in the order specified below.
• 2 Screws (P Tightening; M3x8)
CAUTION:
• Be sure to firmly hold the Connector Fixation Block when tightening the screws.
• Be sure to follow the correct order to tighten the screws, otherwise the Conversion
Connector may not be connected properly, resulting in poor contact.
x2
9
Installation > [TYPE-8] Option HDD (80GB) + Removable HDD Kit + HDD Mirroring Kit or HDD Data Encryption & Mirroring Kit > Installation Procedure > Disass
F-9-488
Boss
Hole
F-9-489
9 Installation > [TYPE-8] Option HDD (80GB) + Removable HDD Kit + HDD Mirroring Kit or HDD Data Encryption & Mirroring Kit > Installation Procedure > Disass
5) Install the HDD Cover.
• 1 Claw
• 1 Screw (TP Round End; M3x6)
CAUTION:
Be sure to use the round end screw included in the Removable HDD Kit as the TP screw.
Claw
6) Install the HDD Handle.
• 2 Screws (TP Round End; M3x6)
CAUTION:
Be sure to use the round end screw included in the Removable HDD Kit as the TP screw.
x2
9-244
F-9-490
F-9-491
9-244