Canon imageRUNNER ADVANCE 6075 Series Service Manual page 1323

4) Secure the Signal Cable and the Power Supply Cable in place using the 2 Wire Saddles at
the back of the HDD Case Unit.
5) Free the cables from the 3 Wire Saddles at the front, and pull out the extra lengths of the
cables to the front.
x2
6) Fold extra length of the Cable and secure it in place using the 2 Wire Saddles [A].
x2
9
Installation > [TYPE-11] Option HDD (250GB) + Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Installing th
F-9-650
[A]
F-9-651
9 Installation > [TYPE-11] Option HDD (250GB) + Removable HDD Kit + HDD Data Encryption & Mirroring Kit > Installation Procedure > Installing th
7) Connect the STS Cable (340mm (Light Blue); FM3-9152) to the Main Controller PCB 2 and
the Encryption Board.
• 2 Connectors
• 1 Edge Saddle
• 5 Wire Saddles
CAUTION:
Check that the STS Cable is connected properly at the time of installation because the
machine can operate even when the cable is not connected properly.
Connector
x6
8) Install the LED Board to the side surface of the HDD Case Unit.
• 2 Screws (TP; M3x6)
9-326
Connector
F-9-652
x2
F-9-653
9-326