Specifications; Parts Configuration - Canon imageRUNNER ADVANCE 6075 Series Service Manual

2
Technology > Fixing > Overview > Parts configuration

■ Specifications

Item
Fixing method IH fixing method
Fixing Heater IH heater
Fixing Roller O/D: 40mm
Pressure Roller O/D: 38mm
Control temperature (Japanese model)
• imageRUNNER ADVANCE 6075/6065:
To be reduced accordingly from 185 deg C (17 deg or more of
environment temperature at standby)
To be reduced accordingly from 190 deg C (less than 17 deg C of
environment temperature at standby)
• imageRUNNER ADVANCE 6055:
To be reduced accordingly from 180 deg C (17 deg or more of
environment temperature at standby)
To be reduced accordingly from 190 deg C (less than 17 deg C of
environment temperature at standby)
(Non-Japanese model)
• To be reduced accordingly from 190 deg C (17 deg or more of
environment temperature at standby)
• To be reduced accordingly from 195 deg C (less than 17 deg C of
environment temperature at standby)
Fixing drive control Switching the print speed and warm-up speed (low speed)
Thermistor Main Thermistor (contact type)
The center of the Fixing Roller, Reciprocating width: 12mm
Temperature control, Failure detection
Sub Thermistor (contact type)The rear of the Fixing Roller, No reciprocation
Failure detection
Shutter Thermistor(contact type)
The rear of the Fixing Roller, No reciprocation
Failure detection,Shutter Control
Thermal Switch 1 pc. (non-contact type)
Protective function Yes (detection by the Thermistor and the Thermal Switch)
Separation mechanism Upper Separation Claw: contact type, Reciprocating width: 3mm
Static Eliminator Fixing Roller/ Pressure Roller/Shutter
Cleaning mechanism Fixing Cleaning Web
Inlet guide height No
control
Bias application No
Control to prevent control of heating area by flux blocking plate (shutter)
temperature rise at the
edge
Disengagement No
mechanism
idle rotation during Yes
standby
Other controls See "Controls" described later.
2 Technology > Fixing > Overview > Parts configuration
Function/method
T-2-49

■ Parts configuration

● Cross-section view
Fixing Cleaning
Web takeup roller
Fixing Cleaning Web
Heater Unit
Shutter Static
eliminator2
Upper
separation claw
Pressure roller
Static eliminator
Parts name
Fixing Roller Heating toner and paper
Pressure Roller Pressing and feeding paper
Heater Unit IH Heater
To heat the Fixing Roller
Coil Core
Fixing Cleaning Web To remove residual toner on the surface of the Fixing Roller
Fixing Cleaning Web Roller
Fixing Cleaning Web Take-up
Roller
Fixing Cleaning Web Feed Roller
Upper Separation Claw To separate paper from the Fixing Roller (to prevent paper-
wrapping)
Reciprocating width: 3mm
Fixing Inlet Guide Paper Feed Guide to the Fixing Assembly
Fixing Roller Static Eliminator To prevent leak, static offset and noise
Pressure Roller Static Eliminator
Shutter Static Eliminator
2-98
Fixing Cleaning
Web feed roller
Fixing Cleaning
Web roller
Fixing Roller
Static eliminator
Shutter Static
eliminator1
coil, core
Fixing Roller
Fixing inlet guide
Pressure roller
F-2-127
Function/method
T-2-50
2-98