1) If the machine is on, go through the shut-down instructions appearing on the control panel screen so that the main power switch may be turned off. (The main

power will go off automatically.)

2) Connect the USB device to the USB port.

3) Put the machine in download mode (normal or safe).

4) Go through the instructions indicated on the control panel, and press the appropriate key.

[2] -> [0]: execute download / other than [0]: go back to Menu screen

MEMO:

If the system software in the USB device is found to be of the same or older version, a message will appear asking you if you want to overwrite. Go though the

instructions on the control panel, and press the appropriate key.

[0]: overwrite / other than [0]: do not overwrite

5) While downloading is under way, the control panel screen shows its progress. At the end of downloading, a message will appear asking you to press a key. Press

the appropriate key. If the machine is in normal mode, it starts the shut-down instructions.

6) When a message appears asking you to turn off the power, turn off the main power switch, remove the USB device, and turn on the main power switch.

7) Upon start-up, the machine starts to write the system software to the system area of the HDD or the flash ROM. At the end of writing to the HDD, a message

will appear asking you to turn off and then back on the power. Turn off and then back on the main power switch.