Error Messages - NEC Univerge sv8500 Manual

In normal occasion:
2A-MC>EXIT
When SAVE command has not bee executed after data change:
2A-MC>EXIT
Configuration data is changed. Does it save and end?
Y: It saves and ends.
N: It ends without saving.
C: Cancel
[Y/N/C]: Y
Configuration data has been changed!!
The screen returns to the prompt of the maintenance command (2A-MC, in default) if any error occurs when
Note:
"Y" is selected after changing the configuration data.

4.5 Error Messages

When an error occurs using the maintenance commands, an error message is generated. This message will help
find solutions for re-assignment of the required data.
ERROR MESSAGE
Command not found.
Entered parameter is illegal.
It has made a mistake in the address
form.
Out of memory range.
Parameter is over digit.
Please enter sub command.
Range is illegal.
Sub command not found.
The inputted command cannot be distin-
guished.
The inputted key name is not used.
The inputted section name is not used.
This character is not support.
List of Error Messages
Command not found (a command other than the supported command is
entered).
The entered parameter is illegal (a parameter other than expected is en-
tered).
The form of the entered address is different.
Out of memory range.
The specified memory address exceeds the number of digit.
Required sub command has not been entered.
The specified range is illegal.
The entered sub command is not correct.
The system cannot recognize the entered command.
The entered key name is not correct.
The entered section name is not correct.
The entered command includes an unsupported character.
VOL.2-107
Analog 2MC (Analog Media Converter)
Line 1:
Line 2: Normal occasion
Line 1:
Line 2:
Line 3:
Line 4:
Line 5:
Line 6: Select Y to make the changed configura-
tion data effective and exit the mainte-
nance command
Line 7: Result is shown
CAUSE