NEC Univerge sv8500 Manual page 356

18. To show the setting of Ringer Voltage:
2A-MC>SHOW RINGVOLTAGE
Voltage of ringer is 75Vrms.
2A-MC>_
This command is available for Analog 2MC firmware Issue 3 or later.
Note:
19. To show default value of sender PAD:
2A-MC>SHOW SENDPAD
Default Sender PAD is 0.
2A-MC>_
The Sender PAD is inserted in the direction of the analog terminal to the IP.
Note:
20. To show RTP Start Port:
2A-MC> SHOW STARTPORT
Number of RTP start port is 1024.
2A-MC>_
21. To show Stutter Dial Tone:
2A-MC> SHOW STUTTERDT
Stutter Dial Tone is Enable.
2A-MC>_
22. To show Synchronous Ringing:
2A-MC> SHOW SYNCRINGING
Synchronous Ringing is ON.
2A-MC>_
Analog 2MC (Analog Media Converter)
Line 1:
Line 2: The current setting is shown
Line 1:
Line 2: The current setting is shown
Line 3:
Line 1:
Line 2: The current setting is shown
Line 3:
Line 1:
Line 2: Registered setting is shown
Line 3:
Line 1:
Line 2: Registered setting is shown
VOL.2-103