NEC Univerge sv8500 Manual page 358

DELETE COMMAND
To delete the VLAN setting:
2A-MC> DELETE VLAN 1
VLAN device remove complete.
Is this setup made to reflect immediately?[Y/N]: Y
VLAN device delete complete.
2A-MC>_
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand
SAVE COMMAND
To save the configuration data to Flash ROM:
2A-MC>SAVE CONFIGDATA
May I save? [N/Y]: Y
erase start...
erase OK!
write start...
write OK!
Checksum write. OK!
Preservation of configuration data was successful.
Re-starting is required for making a setup reflect!!
2A-MC>SAVE CONFIGDATA
May I save? [N/Y]: N
Configuration data has not been saved.
2A-MC>_
GET COMMAND
To download Configuration Data file from specified TFTP server:
Analog 2MC (Analog Media Converter)
Line 1: Specify the VLAN_ID to be deleted in the
range of 1-4095
Line 2:
Line 3: Select Y or N, whether to apply the deleted
data immediately
Line 4: Result is shown
Line 1:
Line 2: Select either, Y or N
Line 3: When Y is selected
Line 4:
Line 5:
Line 6:
Line 7:
Line 8: Result is shown
Line 1:
Line 2: When N is selected
Line 3: Result is shown
Line 4:
VOL.2-105