NEC Univerge sv8500 Manual page 346

20. Setting default value of sender PAD:
2A-MC>SET SENDPAD 0
Default Sender PAD setting succeeded.
2A-MC>_
The SENDPAD command assigns the value to decrease voice level in the sender (analog terminal to IP)
Note:
direction.
The total PAD value (Sender PAD + Fax Sender PAD) is limited to 15dB.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
21. Setting RTP Start Port:
2A-MC>SET STARTPORT 1024
Number of RTP start port setting succeeded.
2A-MC>_
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
22. Setting Stutter Dial Tone:
2A-MC>SET STUTTERDT ENABLE
Stutter Dial Tone setting succeeded.
2A-MC>_
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
Analog 2MC (Analog Media Converter)
Line 1: Enter the PAD value in the range of 0-15 after the
command name (default=0)
Line 2: Result is shown
Line 1: Enter the number of RTP Start Port in the range
of 1024-65534 (default=1024)
Line 2: Result is shown
Line 1: Enter ENABLE or DISABLE
ENABLE=Stutter Dial Tone is valid
DISABLE=Stutter Dial Tone is invalid (default)
Line 2: result is shown
VOL.2-93