NEC Univerge sv8500 Manual page 343

11. Setting the Health Check Timer value:
2A-MC>SET HEALTHCHECKTIMER 120
Health check timer setting succeeded.
2A-MC>_
Available for SP-3753 2AMC PROG-B 8A or later.
Note:
The action starts after the timer value that you set and the extra 30 seconds (150-330).
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
12. Setting the communication speed for LAN interface:
2A-MC>SET INTERFACE
SPEED (AUTO/100M/10M):
DUPLEX (FULL/HALF):
Ethernet Speed setting succeeded.
2A-MC>_
The DUPLEX setting is not shown when Auto Negotiation (AUTO) is selected in the Speed setting.
Note:
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
13. Setting IP Address and Net Mask:
2A-MC>SET IPADDRESS 10.4.128.5 255.255.255.0
IP address set complete.
2A-MC>_
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
The designated IP address cannot be applied when the DHCP is set to ENABLE. Assign the DHCP setting
Note:
to DISABLE before performing this IP address assignment.
axDev0
10M
HALF
VOL.2-90
Analog 2MC (Analog Media Converter)
Line 1: Enter the timer value in the range of 120-300 after
the command name (default = 120).
Line 2: Result is shown.
Line 1:
Line 2: Select the communication speed
AUTO=Auto Negotiation
100M=100 Mbps fixed mode
10M=10 Mbps fixed mode
Line 3: Select the Duplex mode
FULL=Full Duplex mode
HALF=Half Duplex mode
Line 4: Result is shown
Line 1: Enter the IP Address, then Subnet Mask after a
space
Line 2: Result is shown