NEC Univerge sv8500 Manual page 348

25. Setting VLAN:
2A-MC>SET VLAN
Please enter a parameter.
VLAN_ID: 1
COS: 0
IP Address: 172.16.1.1
Subnet mask: 255.255.255.0
VLAN device setting complete.
Is this setup made to reflect immediately?[Y/N]: Y
VLAN device setup complete.
2A-MC>_
To make this assignment effective, use the SAVE command, and restart before exiting the maintenance com-
Note:
mand.
<Examples for VLAN setting>
- Setting procedure when fixed IP address is used:
[1] Disable DHCP
[2] VLAN ID and IP address setting
[3] Existing LAN IP address setting
[4] Default Gateway setting
[5] DRS address setting
The screen shows the assignment of the following value as an example:
VLAN ID:
VLAN Priority:
VLAN IP Address:
Existing LAN IP Address 0.0.0.0 (Set to disabled, because the IP address of existing LAN is not used)
Default Gateway:
DRS Address:
Note 1
5
3
10.10.10.1
10.10.10.254
10.41.207.217
VOL.2-95
Analog 2MC (Analog Media Converter)
Line 3: Enter the VLAN_ID in the range of 1-4095
(VLAN_ID=1 is standard setting)
Line 4: Enter the COS (Priority) in the range of 0-7
(5 is recommended)
Line 5: Enter the IP Address of VLAN
Line 6: Enter the Subnet Mask of VLAN
Line 7:
Line 8: Select Y or N, whether to apply the setting
immediately
Line 9: Result is shown