Mac-Address-Table Station-Move Time-Interval; Mac-Address-Table Station-Move Refresh-Arp - Dell Force10 S4810P Reference Manual

Version 7.5.1.0
pre-Version
6.2.1.1
Usage For information about the specific trap sent and the corresponding Syslog, refer to the
Information Traps

mac-address-table station-move time-interval

Reduce the amount of time FTOS takes to detect aged entries and station moves.
E-Series
Syntax [no] mac-address-table station-move time-interval number
Parameters
time-interval
number
Defaults 5000 ms
Command Modes CONFIGURATION
Command History
Version 7.8.1.0
Usage FTOS takes four to five seconds to detect aged entries and station moves because the MAC
Information address table scanning routine runs every 5000 ms by default. To achieve faster detection,
reduce the scanning interval.

mac-address-table station-move refresh-arp

Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a
topology change.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax [no] mac-address-table station-move refresh-arp
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
1032
Introduced on the C-Series.
Introduced on the E-Series.
chapter.
Select the interval of the successive scans of the MAC address table
that are used to detect a aged entries and station moves. The range is
500 to 5000 ms.
Introduced on the E-Series.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
SNMP