Neighbor Weight - Dell MXL 10GbE Reference Manual

To use the closest interface, use the no neighbor {ip-address | peer-
group-name} update-source interface command.
Parameters
ip-address
peer-group-
name
interface
Defaults Not configured.
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
Usage Loopback interfaces are up constantly and the BGP session may need one
Information interface constantly up to stabilize the session. The neighbor update-source
command is not necessary for directly connected internal BGP sessions.

neighbor weight

Assign a weight to the neighbor connection, which is used to determine the best path.
Syntax
neighbor {ip-address | peer-group-name} weight weight
To remove a weight value, use the no neighbor {ip-address | peer-
group-name} weight command.
Parameters
ip-address
peer-group-
name
weight
Defaults 0
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
356
Enter the IP address of the peer router in dotted decimal
format.
Enter the name of the peer group to disable all routers within
the peer group.
Enter the keyword loopback then a number of the
Loopback interface. The range is from 0 to 16383.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the IP address of the peer router in dotted decimal
format.
Enter the name of the peer group to disable all routers within
the peer group.
Enter a number as the weight. The range is from 0 to 65535.
The default is 0.
Introduced on the MXL 10/40GbE Switch IO Module.
Border Gateway Protocol IPv4 (BGPv4)