Router Bgp - Dell MXL 10GbE Reference Manual

To stop redistribution of OSPF routes, use the no redistribute ospf
process-id command.
Parameters
process-id
match external
{1 | 2}
match internal
route-map
map-name
Defaults Not configured.
Command

ROUTER BGP

Modes
Command
Version 9.2(0.0)
History
Usage
With the Dell Networking OS version 8.3.1.0 and later, you can use the
Information
redistribute command to advertise the IGP cost as the MED on redistributed
routes. When you set the route-map with metric-type internal and apply outbound
to an EBGP peer/peer-group, the advertised routes corresponding to those peer/
peer-groups have the IGP cost set as MED.
When you enter the redistribute isis process-id command without any
other parameters, the system redistributes all OSPF internal routes, external type 1
routes, and external type 2 routes. RFC does not support this feature.
router bgp
To configure and enable BGP, enter ROUTER BGP mode.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number
Defaults Not enabled.
360
Enter the number of the OSPF process. The range is from 1
to 65535.
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
(OPTIONAL) Enter the keywords match internal to
redistribute OSPF internal routes only.
(OPTIONAL) Enter the keywords route-map then the name
of a configured route map.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the AS number. The range is from 1 to 65535 (2 byte),
from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535
(dotted format).
Border Gateway Protocol IPv4 (BGPv4)