Mac-Address-Table Station-Move Threshold; Mac-Address-Table Station-Move Refresh-Arp - Dell S4810 Reference Manual

mac-address-table station-move threshold

Change the frequency with which the MAC address station-move trap is sent after a MAC address
changes in a VLAN. A trap is sent if a station move is detected above a threshold number of times in a
given interval.
S4810
Syntax
[no] mac-address-table station-move threshold number interval
count
Parameters
threshold
number
interval
seconds
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage For information about the specific trap sent and the corresponding Syslog, refer to
Information the

mac-address-table station-move refresh-arp

Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs
due to a topology change.
S4810
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command CONFIGURATION
Modes
1032
Enter the keyword threshold then the number of times
MAC addresses in VLANs can change before an SNMP trap is
sent. The range is from 1 to 10.
Enter the keyword interval then the number of seconds.
The range is from 5 to 60.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series.
Introduced on the E-Series.
SNMP Traps chapter.
Layer 2