Mac-Address-Table Station-Move Refresh-Arp - Dell S6100 Configuration Manual

vlan vlan-id
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.1(0.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
7.6.1.0
7.5.1.0
pre-6.2.1.1
Example (Unicast) mac-address-table static 00:01:00:00:00:01 {output Te 1/1/2/1 vlan 2}
Example (Multicast) mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range Te
1/1/2/1, Te 1/1/3/1}
Related Commands
•

mac-address-table station-move refresh-arp

Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology change.
Syntax mac-address-table station-move refresh-arp
922 Layer 2
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Added support for output range parameter for S4810 and Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on the E-Series.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
show mac-address-table — display the MAC address table.