Mac-Address-Table Station-Move Threshold; Mac-Address-Table Station-Move Refresh-Arp - Dell S4810 Reference Manual

mac-address-table station-move threshold

Change the frequency with which the MAC address station-move trap is sent after a MAC address
changes in a VLAN. A trap is sent if a station move is detected above a threshold number of times in a
given interval.
S4810
Syntax
[no] mac-address-table station-move threshold number interval
count
Parameters
threshold
number
interval
seconds
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage For information about the specific trap sent and the corresponding Syslog, refer to
Information the

mac-address-table station-move refresh-arp

Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs
due to a topology change.
S4810
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command CONFIGURATION
Modes
Layer 2
Enter the keyword threshold then the number of times
MAC addresses in VLANs can change before an SNMP trap is
sent. The range is from 1 to 10.
Enter the keyword interval then the number of seconds.
The range is from 5 to 60.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series.
Introduced on the E-Series.
SNMP Traps chapter.
1041