Neighbor Remote-As - Dell MXL 10GbE Reference Manual

For passive eBGP limits, the Remote AS must be different from the AS for this
neighbor.
Related
neighbor soft-reconfiguration inbound
Commands
configured BGP neighbor.

neighbor remote-as

group.
neighbor remote-as
Create and specify the remote peer to the BGP neighbor.
Syntax
neighbor {ip-address | peer-group-name} remote-as number
To delete a remote AS entry, use the no neighbor {ip-address | peer-
group-name} remote-as number command.
Parameters
ip-address
peer-group-
name
number
Defaults Not configured.
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
Usage
To accept 4-byte formats before entering a 4 byte AS Number, configure your
Information
system. If the number parameter is the same as the AS number used in the router
bgp command, the remote AS entry in the neighbor is considered an internal BGP
peer entry.
This command creates a peer and the newly created peer is disabled (Shutdown).
Related
router bgp
Commands
bgp four-octet-as-support
350
— assigns an indirectly connected AS to a neighbor or peer
Enter the IP address of the neighbor to enter the remote AS
in its routing table.
Enter the name of the peer group to enter the remote AS
into routing tables of all routers within the peer group.
Enter a number of the AS. The range is from 0 to 65535 (2
byte) or from 1 to 4294967295 (4 byte).
Introduced on the MXL 10/40GbE Switch IO Module.
— enters ROUTER BGP mode and configures routes in an AS.
— enables 4-byte support for the BGP process.
— assigns a subnet to a dynamically
Border Gateway Protocol IPv4 (BGPv4)