Neighbor Ebgp-Multihop - Dell MXL 10GbE Reference Manual

neighbor ebgp-multihop

Attempt and accept BGP connections to external peers on networks that are not directly connected.
Syntax
neighbor {ip-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ip-address |
peer-group-name} ebgp-multihop command.
Parameters
ip-address
peer-group-
name
ttl
Defaults Disabled.
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
Usage To prevent loops, the neighbor ebgp-multihop command does not install the
Information default routes of the multihop peer. Networks not directly connected are not
considered valid for best-path selection.
neighbor fall-over
Enable or disable fast fall-over for BGP neighbors.
Syntax
neighbor {ipv4-address | peer-group-name} fall-over
To disable, use the no neighbor {ipv4-address | peer-group-name}
fall-over command.
Parameters
ipv4-address
peer-group-
name
Defaults Disabled.
Command ROUTER BGP
Modes
Border Gateway Protocol IPv4 (BGPv4)
Enter the IP address of the neighbor in dotted decimal
format.
Enter the name of the peer group.
(OPTIONAL) Enter the number of hops as the Time to Live
(ttl) value. The range is from 1 to 255. The default is 255.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the IP address of the neighbor in dotted decimal
format.
Enter the name of the peer group.
343