Debug Ip Bgp Updates - Dell MXL 10GbE Reference Manual

Parameters
ip-address
peer-group-
name
Defaults Disabled
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
Usage
This command turns on BGP soft-reconfiguration inbound debugging. If no
Information
neighbor is specified, debug turns on for all neighbors.

debug ip bgp updates

Allows you to view information about BGP updates.
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] updates [in | out] command.
Parameters
in
out
prefix-list
prefix-list-
name
ip-address
peer-group-
name
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
Border Gateway Protocol IPv4 (BGPv4)
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group..
Introduced on the MXL 10/40GbE Switch IO Module.
(OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
(OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
(OPTIONAL) Enter the keyword prefix-list then the
name of an established prefix list. If the prefix list is not
configured, the default is permit (to allow all routes).
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group.
Introduced on the MXL 10/40GbE Switch IO Module.
335