Enable Jumbo Mtu; Enable Switchport; Enable Link Level Flow Control (802.3X); Configure Spanning Tree On Edge Ports - Dell Brocade VDX 6740 Configuration Manual

2.7

Enable Jumbo MTU

sw0(config)#interface TenGigabitEthernet 1/0/1-48
sw0(conf-if-te-1/0/1-48)# mtu 9216
sw0(conf-if-te-1/0/1-48)# exit
2.8

Enable Switchport

sw0(config)#interface TenGigabitEthernet 1/0/1-48
sw0(conf-if-te-1/0/1-48)# switchport
sw0(conf-if-te-1/0/1-48)# switchport mode access
sw0(conf-if-te-1/0/1-48)# exit
2.9

Enable link level flow control (802.3x)

sw0(config)#interface TenGigabitEthernet 1/0/1-48
sw0(conf-if-te-1/0/1-48)# qos flowcontrol tx off rx on
sw0(conf-if-te-1/0/1-48)# exit
2.10

Configure Spanning tree on edge ports

sw0(config)#protocol spanning-tree rstp
sw0(config-rstp)#exit
sw0(config)#interface TenGigabitEthernet 1/0/1-48
sw0(conf-if-te-1/0/1-48)# spanning-tree edgeport
sw0(conf-if-te-1/0/1-48)# exit
2.11

Disable LLDP iSCSI priority on Switch Ports

sw0(config)#interface TenGigabitEthernet 1/0/1-48
sw0(conf-if-te-1/0/1-48)# no lldp disable
sw0(conf-if-te-1/0/1-48)# no cee
sw0(conf-if-te-1/0/1-48)# no lldp iscsi-priority
sw0(conf-if-te-1/0/1-48)# exit
2.12

Save configuration

switch#copy running-config startup-config
2.13

Configure additional switch

Repeat the commands from Sections 2.1 through 2.12 to configure the second switch.
8 SCG1020 | Brocade VDX 6740 Switch Configuration Guide for EqualLogic SANs