Isis Bfd All-Neighbors - Dell MXL 10GbE Reference Manual

multiplier value
role [active |
passive]
Defaults See Parameters
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History

isis bfd all-neighbors

Enable BFD on all IS-IS neighbors discovered on an interface.
Syntax
isis bfd all-neighbors [disable | [interval interval min_rx
min_rx multiplier value role {active | passive}]]
To remove all BFD sessions with IS-IS neighbors discovered on this interface, use
the no isis bfd all-neighbors [disable | [interval interval
min_rx min_rx multiplier value role {active | passive}]]
command.
Parameters
disable
interval
milliseconds
min_rx
milliseconds
multiplier value
304
Enter the keyword multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
Enter the role that the local system assumes:
• Active — The active system initiates the BFD session.
Both systems can be active for the same session.
• Passive — The passive system does not initiate a
session. It only responds to a request for session
initialization from the active system.
The default is Active.
Introduced on the MXL 10/40GbE Switch IO Module.
(OPTIONAL) Enter the keyword disable to disable BFD on
this interface.
(OPTIONAL) Enter the keywords interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is from 50 to 1000. The
default is 100.
Enter the keywords min_rx to specify the minimum rate at
which the local system would like to receive control packets
from the remote system. The range is from 50 to 1000. The
default is 100.
Enter the keywords multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
Bidirectional Forwarding Detection (BFD)