Bgp Client-To-Client Reflection - Dell MXL 10GbE Reference Manual

bgp client-to-client reflection

Allows you to enable route reflection between clients in a cluster.
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the no bgp client-to-client
reflection command.
Defaults Enabled when a route reflector is configured.
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
Usage Route reflection to clients is not necessary if all client routers are fully meshed.
Information
Related
bgp cluster-id
Commands
neighbor route-reflector-client
bgp cluster-id
Assign a cluster ID to a BGP cluster with more than one route reflector.
Syntax
bgp cluster-id {ip-address | number}
To delete a cluster ID, use the no bgp cluster-id {ip-address | number}
command.
Parameters
ip-address
number
Defaults Not configured.
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
Usage
When a BGP cluster contains only one route reflector, the cluster ID is the route
Information
reflector's router ID. For redundancy, a BGP cluster may contain two or more route
reflectors. Assign a cluster ID with the bgp cluster-id command. Without a
cluster ID, the route reflector cannot recognize route updates from the other route
reflectors within the cluster.
Border Gateway Protocol IPv4 (BGPv4)
Introduced on the MXL 10/40GbE Switch IO Module.
— assigns an ID to a BGP cluster with two or more route reflectors.
— configures a route reflector and clients.
Enter an IP address as the route reflector cluster ID.
Enter a route reflector cluster ID as a number from 1 to
4294967295.
Introduced on the MXL 10/40GbE Switch IO Module.
317