Bgp Router-Id - Dell MXL 10GbE Reference Manual

Routing Protocol is "bgp 1"
Regular expression evaluation optimization enabled
Dell(conf-router_bgp)#
Related show ip protocols
Commands

bgp router-id

Assign a user-given ID to a BGP router.
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback
interfaces are configured, the highest IP address of a physical interface on the
router.
Command ROUTER BGP
Modes
Command
Version 9.2(0.0)
History
Usage
Peering sessions are reset when you change the router ID of a BGP router.
Information
bgp soft-reconfig-backup
To avoid the peer from resending messages, use this command only when route-refresh is not
negotiated.
Syntax
bgp soft-reconfig-backup
326
Area
51
Cluster Id is set to 10.10.10.0
Router Id is set to 10.10.10.0
Fast-external-fallover enabled
Capable of ROUTE_REFRESH
For Address Family IPv4 Unicast
BGP table version is 0, main routing table version 0
Distance: external 20 internal 200 local 200
— views information on all routing protocols enabled and active.
Enter an IP address in dotted decimal format to reset only
that BGP neighbor.
Introduced on the MXL 10/40GbE Switch IO Module.
Routing for Networks
10.10.10.0/00
Border Gateway Protocol IPv4 (BGPv4)