Parameters
half-life
reuse
suppress
max-suppress-
time
route-map
map-name
Defaults
Disabled.
Command
•
Modes
•
Command
Version 9.2(0.0)
History
Usage
If you enter the bgp dampening command, the default values for half-life,
Information
reuse, suppress, and max-suppress-time are applied. The parameters are
position-dependent; therefore, if you configure one parameter, configure the
parameters in the order they appear in the CLI.
Related
show ip bgp dampened-paths
Commands
320
(OPTIONAL) Enter the number of minutes after which the
Penalty is decreased. After the router assigns a Penalty of
1024 to a route, the Penalty is decreased by half after the
half-life period expires. The range is from 1 to 45. The default
is 15 minutes.
(OPTIONAL) Enter a number as the reuse value, which is
compared to the flapping route's Penalty value. If the Penalty
value is less than the reuse value, the flapping route is once
again advertised (or no longer suppressed). The range is from
1 to 20000. The default is 750.
(OPTIONAL) Enter a number as the suppress value, which is
compared to the flapping route's Penalty value. If the Penalty
value is greater than the suppress value, the flapping route is
no longer advertised (that is, it is suppressed). The range is
from 1 to 20000. The default is 2000.
(OPTIONAL) Enter the maximum number of minutes a route
can be suppressed. The default is four times the half-life
value. The range is from 1 to 255. The default is 60 minutes.
(OPTIONAL) Enter the keyword route-map then the name
of a configured route map.
Only match commands in the configured route map are
supported.
ROUTER BGP
ROUTER BGP-address-family
Introduced on the MXL 10/40GbE Switch IO Module.
— views the BGP paths.
Border Gateway Protocol IPv4 (BGPv4)