Verifying The Stack; Figure 101: Show Stack Command - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Verifying the Stack

awplus> show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
2 -
3 -
4 -
Operational Status
Stack MAC address
To verify the stack, perform the following procedure:
1. Start a local management session on any switch in the stack. Refer to
"Starting a Local Management Session" on page 157.
2. From the User Exec mode, enter the SHOW STACK command:
awplus> show stack
An example of the command for a stack of four switches is shown in
Figure 101.
MAC address
e01a:ea20:8011
e01a:ea20:8012
e01a:ea20:8050
e01a:ea20:8029
Figure 101. SHOW STACK Command
Review the following items:

The command should list all of the switches in the stack. If the list
is incomplete, refer to Chapter 9, "Troubleshooting" on page 213.
 The Operational Status field should be "Normal operations" to
indicate that all the stacking ports are operating normally.
 If the Operational Status field is displaying "Not all stack ports are
up," one or more stacking ports are not being used or cannot
establish links with their counterparts. For more information, refer
to Chapter 9, "Troubleshooting" on page 213.
3. Go to Chapter 7, "Cabling XEM2 Line Card Ports" on page 177, to
complete the installation.
SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
Priority Status
1 Ready
2 Ready
3 Ready
4 Ready
Normal operations
0015:774f:ed30
Role
Active Master
Backup Member
Backup Member
Backup Member
175