Table of Contents
Advertisement
Disabling the VCStack Feature
awplus> show stack
Virtual Chassis Stacking summary information
ID
Pending ID
1
-
Operational Status
Stack MAC address
awplus>
The following procedures explain how to disable the VCStack feature to
use the switch as a stand-alone unit.
Caution
Disabling the VCStack feature requires resetting the switch. Some
network traffic can be lost if the switch is connected to a live
network. E89
To disable the VCStack feature, perform the following procedure:
1. Start a local management session on the switch. For instructions, refer
to "Starting a Local Management Session" on page 93.
2. To display the status of the VCStack feature on the switch, at the User
Exec mode prompt, type the command SHOW STACK.
MAC address
eccd:6dd1:64a2
Figure 43. SHOW STACK Command
3. If the Operational Status of the switch is "Stacking Hardware
Disabled," the VCStack feature is already disabled on the unit. If
this is the case, go to Chapter 8, "Cabling the Networking Ports" on
page 99.
However, if the Operational Status is "Standalone Unit" as shown in
Figure 43, the VCStack feature is active on the unit. (The "Standalone
Unit" status means the switch is functioning as a stack of one switch.)
You must disable the feature to use the switch as a stand-alone unit.
Continue with the next step.
x530 Series Installation Guide for Stand-alone Switches
Priority
Status
128
Ready
Standalone Unit
eccd:6dd1:64a2
Role
Active Master
95
Advertisement
Table of Contents
