Verifying The Stack; Figure 50: Show Stack Command - Allied Telesis x530DP Series Installation Manual

Verifying the Stack

awplus> show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
2 -
3 -
4 -
Operational Status
Stack MAC address
To verify the stack, perform the following procedure:
1. Start a local management session on any switch in the stack. Refer to
"Starting a Local Management Session" on page 136.
2. From the User Exec mode, enter the SHOW STACK command:
awplus> show stack
An example of the command for a stack of four switches is shown in
Figure 50.
MAC address
e01a:ea20:8011
e01a:ea20:8023
e01a:ea20:9a45
e01a:ea20:1b8a
Figure 50. SHOW STACK Command
Review the following items:
The command should list all the switches. If the list is incomplete,

refer to Chapter 11, "Troubleshooting" on page 161.
The Operational Status field should be "Normal operations" to

Indicate that all the stacking ports are operating normally.
If the Operational Status field is displaying "Not all stack ports are

up," one or more stacking ports are not being used or cannot
establish links with their counterparts. For more information, refer
to Chapter 11, "Troubleshooting" on page 161.
3. Go to Chapter 10, "Cabling the Networking Ports" on page 153, to
complete the installation.
x530DP Series Installation Guide for Virtual Chassis Stacking
Priority Status
1 Ready
2 Ready
3 Ready
4 Ready
Normal operations
e01a:ea20:8011
Role
Active Master
Backup Member
Backup Member
Backup Member
151